Clippable DeWalt tstak floor and wall mount (1 set)

3d printed Please install them by putting them onto tool box Used for wall or floor mounting a dewalt tstak box (fits all versions). Pictured with tstak IV here Screws are supplied (the ones in the pictures are 4 mm x 20 / 0.157 inch x 0.787 inch) How to install: - Put the clamp inside the holes of the mounting blocks. Make sure the mounting holes are facing outside of the box. - Before you put in the screws position the blocks by hand in a way that will make the box drop in the same way as in the pictures (Once it gets in the right position you will notice it will visibly drop a few mm/a fraction of an inch) - make sure you get the blocks as tight as you can so that the box will not slide forwards / backwards after you fasten the screws - fasten the screws while simultaneously holding the blocks down so they will not shift their positions